The use of innovations and new technologies at Hageris always customer-driven. Every year, Hager evaluatesthousands of its customer contacts, resulting in detailedknowledge of its customers’needs in order to workefficiently and successfully.
Poznámky redaktora
With masks and
narrow covers
Switch for sec. a
result, the heat movement people, animals light sources can trip the controller,
which then switches consumers such lighting.T25
Operating principle
Controllers respond heat movement the infrared light band. For this controller with enhanced approach response (controller 70, Berker
control) should configured.2 mounting)
Controller surface mounted
Controller 70
Limitation detection range locked settings for
ranges m. prevent lights installed within the detection range tripping the
controller, the controller response delayed seconds.) which the detection angle individual controller not sufficient, controllers
with extension units, controller system, networked Berker controls radio controllers should deployed, with the detection ranges of
the individual devices overlapping.
Important planning criteria for controller installation
The mounting height the controller set out the tables should complied
with, failure will result restricted range excessive range. Where there little temperature difference
between the object being detected and the ambient temperature, range restrictions
may occur. Lamps such incandescent and halogen
lamps etc.
At the recommended mounting height the detection height can adjusted,
depending the controller, means tilting and locking and using the hoods,
covers, masks and adhesive labels supplied, thereby avoiding unwanted switching.
Extension units
When using BLC
controllers with BLC
extension units, a
generous overlap
between the detection
ranges should allowed
in order ensure
detection.
If the controller system sensor 240 tilted, the
detection angle should reduced 180°, otherwise
excessive lateral range will occur. The unit remains long as
movements are detected, otherwise the controller switches off the end the
pre-set delay time. Parallel connection controllers not advisable, because may cause so-called reciprocal action
(switching back again after short cut-out approx. also emit considerable amounts heat this range too, however. The controller's
detection beams are then crossed laterally.
min. sec).
Controller system sensors 180 and 240
Limitation detection range desired with hood, also
by tilting and rotating. There should adequate distance between the light and the controller. the controller placed such that the person being detected appro-
aches the unit only frontally, range restriction expected.
Optimum mounting location
For optimum detection and range for movement, Berker controllers should installed laterally the direction walking.
Automatic Controller Plus 110
Limitation detection range with masks and and
covers, also tilting and rotating.
23
System-Leistungsteil
60°
15 m
15 m
110°
16 m
2,5 m
25°
7 m
15 m
90°
20 m
15 m
110°
25 m
16 m
Tilt
95°
Detection for large areas
For detection larger areas (squares, long corridors etc.
Lamps within the detection range
The lamp being switched must not placed the immediate vicinity underneath the controller, because the radiated heat can cause
unwanted switching.With horizontal cover
With masks and
wide covers
With masks and coversWithout masks and covers
360°
180°
90°
~8 m
Adjustment range
~4 m
Bewegungsrichtung
Test
On
3 Min
TIME
12
Min
LUX
300
10
Test operation
N L
Range
max.
BLC controller lush mounted
BLC controller
BLC controller comfort
Controller system mounting
Limitation detection range only 90° with masking
element different mounting height
(at 2. When using multiple controllers and/or extension units, the detection ranges the individual
controllers should overlap, order ensure optimum monitoring.
Controller
Installation instructions
. this range
that the human body radiates heat.
The ranges the controllers/controller system sensors may vary due the effects
of weather conditions (fog, rain, snow)
