Pohybový detektor
... pro bezpečnost, pohodlí a úspory energie
in fračerven á absorce
Detektory pohybu jsou často určené
pro detekci pohybu zdrojů tepla v
jejich detekčním dosahu a automaticky
spínají připojená světla.
Infračervený snímek:
Ten je vyvolán pomocí pasivní infračervené
technologie. To znamená,
že integrované infračervené senzory
zaregistrují tepelné záření a převedou
ho na elektrický signál. Samotné
čidlo nevysílá žádné záření a
proto je označováno jako pasivní
infračervený senzor (PIR senzor).
After this, the lighting situation desired for the
scene can set and saved e.g.
Especially large systems where the lights a
DALI segment are distributed over
many rooms highly complex, the commission
ing can carried out via mobile notebook
with WLAN card thanks the KNXnet/IP-com-
patibility the software.. from the B. via the conven
tional buttons directly connected the device or
via EIB buttons.
The plus point for large systems: commissioning
via KNXnet/IP and LAN.g.DALICONTROLLER/
DALI/KNXGATEWAY
A with the programming tool only has be
connected the KNX/EIB via any serial inter
face for commissioning.
The system integrator can then move freely
within the building with his notebook and carry
out the commissioning and group assignment
directly the area the lights.
% WLAN
n r
• •
1____ 1
KNX
- <E
- n
<E
n>
n>
n>
DALI
< n
=a:
=a:
n>
n>
n>
-6
SCENE SAVING
When setting scenes and their sequence, is
advantageous the device already configured
by ETS.G.S12 used
4 60% 100%
20
.
Alternatively this, the display and buttons of
the DALI/KNX Gateway can used DALI
controller.
The following are supported for this: RS-232,
USB and KNXnet/IP interfaces. The table represents example a
planning object with two room units.E. KNXnet/IP Inter
face product group) only has connected
to WLAN access point, thereby establishing a
temporary wireless network. The assignment the group the indi
vidual scenes should first planned and then
carried out.
This table entered directly DALI controller
using the display and the programming buttons
on the DALI/KNX Gateway The associated
groups are selected for each scene.
Group
G1 G11 16
Scene
S1 X
S2 X
S3 X
S4 X
S5 X
S6 X
S7 X
S8 X
S9 X
S10 X
S11 X
S12 X
S13
S14
S15
S16
In this exam ple, the scenes are intended for the llo functions:
S1 Central OFF, Central orning Lighting, Central Evening Lighting,
S4 larm Situation, S5..
The scene can saved via EIB button. For this, KNXnet/IP
gateway (e.S8 Partial Scene Room S9.
If stationary WLAN available with cor
responding hotspots, this can also used
for the DALI commissioning with the „DALI
Programming Tool"
