Poznámky redaktora
Value harmonic No
No.2.
Using the and keys you can the bar interest (at the "No.8 ains frequency
Mains Frequency_____________
50.1.5. The minimum value that can displayed
is 0.2.001 MVAh.4.7 Peak factor
Peak factor
I1 --- I3: ---
I2: --- —
On this page you can also measure the peak factor i.15.3xIn and not available for
phase currents above 6xIn.5.9.15 billion kWh kVARh kVAh. the relationship between for each of~ peak rms'
the phases.
118/158
.1.4.9 Contact wear
This submenu shows the percentage wear the contacts.
Model L2234 Apparatus Scale
L 2778
Doc.1.4.
For further information, see par.
For the ranges and precisions see par.e.
15. currently-selected harmonic
Ne Total distorsion y/r:150.2.
Using the keys, you can display the waveforms the following measurement channels (L1, L2, L3,
Ne, V1, V2, V3, Gt). 1), which is
consequently always given 100%. 14.
The measurement precision 5%. 14.15.1.
15. the
page the left displayed, containing the module the harmonics from the 1st the 40th (up the 35th
for mains frequency set 60Hz) given percentage the fundamental (harmonic no. No.001 MVARh 0.
15.1.001 MWh 0.4.
The measurement guaranteed maximum after the change frequency. 2
Page No.1. The energy meters' end scale approximately 2.6 Energy
1 1/2
Enter J
Energy counters
ESC
+ Enter J
Energy 2/2
1 Energy counters
0kWh
0kVARh
0kVAh
Energy counters
Reset counters Reset counters 1
Energycounters Reset counters
15.The unit also provides meter readings the total active, reactive and apparent energy the system." harmonic required, the bar begins
to flash) and read the corresponding percentage value.9. This measurement not displayed for phase currents below 0.0%
Harmonic 1/40 100.5.1 aveform s
When you access this menu page, 120 samples the wave form the selected phase are acquired and
displayed.9.
15.e. For the ranges and precisions see par.6 Data Logger
The data logger active both with Vaux and with power supply from the PR120/V.5.
15. This calculated the voltages (if Umax 0. 16.15.14.
For the ranges and precisions see par.
The meter can also reset pressing the "Reset meters" key the menu.1Un).5.4.0 Hz
Measuredvalue
This page enables you view the mains frequency.4.
When you press the key, new wave form acquired and displayed.0%
You can analyze the harmonic the samples acquired and displayed the "Waveforms" page, i
