Poznámky redaktora
.
Select the value the first figure between '0' and '9' means the and keys and press confirm the figure and then move enter
the next one.13. Select "Uninstall" and press "ENTER"
7.7 Replacing electronic release
13.3.
After entering the fourth figure, check the password you have entered.4). Select "Circuit-breaker
4. With the circuit-breaker open and preferably isolated, install the protection unit the circuit-breaker
2.
Note that ABB SACE defines each possible setting according the content the paragraph the default parameters (see par.7. When the red led flashes and off and the message Installation (installation error) isdisplayed, remove the
PR030/B
10. there are other errors, the display will show the message Configuration (configuration error)accompanied the
yellow LED coming permanently (warning)
4. The values attributable the password from 0000 9999. Input the password
8.
13. Power the relay from any other source
Check for the absence configuration errors.n°. With the circuit-breaker open and/or isolated power the unit from the PR030/B
2.3. Remove the PR122/P unit from the circuit-breaker
9. 13.
13.3.g.5 Initial settings
If the PR122/P supplied ready installed the circuit-breaker, ABB SACE set all the variables referring the circuit-breaker the
specific application correctly (e. Select "Unit installation
5. When the PR120/V module installed, set the Rated Voltage suitably.
By setting the value the password [0000] (on the "Unit configuration" menu) the password prom disabled.
A
A part from this, absolutely indispensable for the user odify the password and carefully define each odifiable
param eter, before putting the PR122/P into service. Power the unit ONLY from the PR030/B
3. Select "Install' and press "ENTER'
9. 2
Page No.
Model L2234 Apparatus Scale
L2778
Doc.4. type circuit-breaker, Rating Plug size .
Disabling the Password.
13.
58/158
.3.).
Vice versa, the PR122/P supplied separately, will the user set all the necessary parameters correctly.13.
To enter new password, select the "New Password" item the "Settings/System" menu.
If the password wrong, the message
W rong password
appears and remains until the ESC key pressed (or until interval seconds has elapsed).
It not strictly necessary complete the uninstalling procedure, but this enables the parameters relating the circuit-breaker, such contact
wear and others, otherwise these data would lost. The remove the connector, proceed indicated the figure alongside.. therefore always possible
to switch from "READ" "EDIT". the password correct, you from the "READ" state the "EDIT" state.7.3. Enter the unit's "Settings' menu
3.
The password valid for maximum two minutes from the last time key was pressed. Enter the unit's “Settings' menu
5.
It also possible interrupt the password entry procedure pressing the ESC key.6 Password anagem ent
Specify password? ***]
To enter "EDIT" mode necessary enter four-figure numerical password.4.4. Select "Unit installation
7.2 sta llin g
To complete the procedure for uninstalling PR122/P unit, follow the steps below:
1.
For the default password see par. Remove the PR030/B module
8. Input the password
6. The data question are then transmitted the new PR122/P unit installed the same
circuit-breaker.1 Installation
To complete the procedure for installing PR122/P unit, follow the steps below:
1. Select “Circuit-breaker
6