Poznámky redaktora
- Insert the hexagonal-head screws (1) the holes found the previous item shown the figure. 8
4.
Model 2234 Apparatus Scale
L 2778
Doc-No' 1SDH000460R0002
Page No.
- Anti-racking-in plate the moving part (5).With regard lifting, follow the instructions: the circuit-breakers must placed sturdy supporting surface and lifted, preferably, means
of special fork-lift truck.
n clu vin sam itio and e
l rear term inals.3.
4.1 Installation room
Install the circuit-breaker dry, dust-free, non-corrosive room, and
in such way that not subject shocks vibrations.
The installation, commissioning and any ordinary and extraordinary
maintenance have done skilled personnel, with detailed
knowledge the apparatus. However, the use ropes allowed.
8/158
.3 Installation fixe the ith circu it-b r
4.
Fig.)
S tiv e
c it-b e
Fixed
3 poles
v n
4 poles
W ithdraw;
3 poles
jb version rre t-
lim itin g
4 poles
Fixed
3 poles
v n
4 poles
W ithdrawa
3 poles
ble version
4 poles
E1 E2L 95
E2 E3L 110 127
E3 104 125
th are inte circu it-b ith 121, 122
elative rre sensors, xclu accessories. 7
Table the circuit-breaker eights (Kg. this case, the lifting ropes must hooked shown the figures (the lifting
plates are always supplied with the circuit-breaker). the anti-racking-in lock has been supplied separately, proceed assemble follows:
- the self-adhesive plate (4), find the assembly position the stop bolts relation the circuit-breaker which has housed the fixed
part.).
Fig.
Make sure that the anti-racking-in lock corresponding the one installed the fixed part present the circuit-breaker (moving part). Where this
is not possible, install inside switchboard with suitable degree of
protection.
- Fix the screws with the washers (2) and the hexagonal stops (3).
For the preparation the installation room, please refer the "Overall
dimensions" paragraph, which gives information the following points:
- minimum installation volumes the circuit-breakers and derived
versions
- distances respected for circuit-breakers compartments
- overall dimensions the circuit-breakers
- fixing drillings
- compartment door drillings.1 Preparation the fixed part
Assem bly the anti-racking-in lock
Before installing the fixed part, necessary check the presence the anti-racking-in lock for circuit-breakers with different electrical
characteristics from those the fixed part.
E4 117 147 165
E4/f 120 170 Notes
E6 140 160 210 240 123 relea ses and
E6/f 165
The ith versio
250 fixed ith horizonta
4.2 Installation fixed circu it-b r
Fix the circuit-breaker horizontal surface using the screws (M10 x
12 min. Installation
4