Poznámky redaktora
4
2. The notification must
indicate the number the shipping note.5 Fixed part construction characteristics
1 Steel sheet supporting structure
2 Earthing contacts (a: for all versions; for E4,
E6)
3 Safety shutters (IP20 degree protection)
4 Insulating terminal support base
5 Terminals
6 ontacts for signalling connected/test
isolated/disconnected (on request)
7 Sliding contacts
8 Padlock for safety shutters (on request))
9 Anti-racking-in lock for circuit-breakers of
different size
10 Fixing holes (qty for E1, E2, E3, for E4, E6)
Fig. Storage, lifting and weights
The circuit-breaker, protected external wooden crate, fixed means screws the transport pallet the bottom the packing
case. the circuit-breaker has remain the warehouse even for short time before being put into service, after checking receipt, must
be put back its container and covered with waterproof sheet.
C aution
- Use dry, dust-free room free aggressive chemical agents storage room
- Position the circuit-breaker and any fixed part horizontal surface, not direct contact with the floor, but suitable support surface
(Fig. Should any damage errors found unpacking,
which must carried out carefully, make the relative notification within and not over days from the receipt the material. Checking receipt
Examine the state the material received and its consistency with the content the order.
7/158
.
Model 2234 Apparatus Scale
L 2778
Doc-No' 1SDH000460R0002
Page No.1. 5)
- The maximum number stackable circuit-breakers indicated figure 6
- Keep the circuit-breaker the open position and with the closing springs unloaded avoid unnecessary stresses and the risk accidents
to the personnel.
3
