Poznámky redaktora
3.
61/108
. Enter the unit's "Settings" menu
3.2 Uninstalling
To complete the procedure for uninstalling PR123/DC unit, follow the steps below:
1.
To enter new password, select the "New Password" item the "Settings/System" menu.3.. When the PR120/V module installed, user must properly set
the rated voltage.
By setting the value the password [0000] (on the "Unit configuration" menu) the password prom disabled.
If the password wrong, the message
Wrong password
appears and remains until the ESC key pressed (or until interval seconds has elapsed). Enter the unit's "Settings" menu
5. When the red led flashes and off and the message Installation (installation error) displayed, remove the PR030/B
10. Input the password
8.. With the circuit-breaker open and preferably isolated, install the protection unit the circuit-breaker
2. Select "Install" and press "ENTER"
9. Select "Unit installation"
7. the password correct, you from the "READ" state
to the "EDIT" state. therefore always possible
to switch from "READ" "EDIT".3.4).
13.4.
13. Power the unit ONLY from the PR030/B
3. Select "Uninstall" and press "ENTER"
7. Power the relay from any other source
11. Select "Unit installation"
5. The values attributable the password from 0000 9999. 13.
It also possible interrupt the password entry procedure pressing the ESC key.3.1 Installation
To complete the procedure for installing PR123/DC unit, follow the steps below:
1.6.
13.3.4.
Model 7
A pparatus Emax DC
S cale
D oc-N 1SDH000635R0002
Page No.
Note that ABB SACE defines each possible setting according the content the paragraph the default parameters (see par.4 Initial settings
If the PR123/DC supplied ready installed the circuit-breaker, ABB SACE set all the variables referring the circuit-breaker or
the specific application correctly (e.13.6 Replacing electronic release
13.). 13.6.4. Select "Circuit-breaker"
4.
Vice versa, the PR123/DC supplied separately, will the user set all the necessary parameters correctly. The remove the connector, proceed indicated the figure alongside. Remove the PR030/B
8. Remove the PR123/DC unit from the circuit-breaker
9. there are other errors, the display will show the message Configuration (configuration error) accompanied the yellow
LED coming permanently (warning)
4.
Select the value the first figure between '0' and '9' means the and keys and press confirm the figure and then move enter
the next one. Check for the absence configuration errors.5 Password management
Specify password? [0***]
To enter "EDIT" mode necessary enter four-figure numerical password. Input the password
6.
Apart from this, absolutely indispensable for the user modify the password and carefully define each modifiable
parameter, before putting the PR123/DC into service. type circuit-breaker, Rating Plug size.
For the default password see par. Select "Circuit-breaker"
6. With the circuit-breaker open and/or isolated power the unit from the PR030/B
2.
Disabling the Password.
It not strictly necessary complete the uninstalling procedure, but this enables the parameters relating the circuit-breaker, such contact
wear and others, saved, otherwise these data would lost. After entering the fourth figure, check the password you have entered. The data question are then transmitted the new PR123/DC unit installed
on the same circuit-breaker.g