ABB Návody k modulárním přístrojům Systém pro M

| Kategorie: Návody k obsluze Montážní návody  | Tento dokument chci!

... ochrana proti nadproudům: musí být použit proudový chránič se zkratovou ochranou, který chrání systém proti přetížení a zkratům. Napájení: zařízení může být napájeno buď ze spodních nebo horních svorek. Montáž: chránič je navržen pro upevnění na symetrickou lištu DIN, podle EN 60715, 35 mm šířky, s rychlosvorkou, která ...

Vydal: ABB s.r.o, ELSYNN Autor: ABB ELSYnn

Strana 397 z 507







Poznámky redaktora
This error message can appear in individual cases.6.General 11 6. Press any key and the time switch will continue run normally. There may read/write errors.1 Error messages The time switch signals malfunctions: • the event incorrect access to the EEProm. • the battery voltage too low. Consult your dealer.4 • Remove the battery casing • Carefully remove the connector • Insert new battery • Carefully insert the connector • Replace the battery casing GB . Transfer the program again. • the event incorrect transfer via the IR interface.6 Service 6. If this error message appears often, recommend that the time switch replaced. Order the battery from your dealer with the article number . 6 Lithium battery (service life, type: see Technical data) If the battery voltage falls below value which does not guarantee functioning the time switch (error message 01) replace the battery. Replacing the battery: • Remove the control section, see