the KNX bus not
connected and the device only powered via micro USB, all Error LEDs will light
up (master and extensions).2020/09
MTN6705-0008 MTN6805-0008 MTN6710-0102 MTN6810-0102
MTN6725-0101
Perform firmware update for the Master devices
SpaceLogic KNX
LED behavior master and extension within the update
–
– The master‘s RUN LED flashes for 30-60 seconds
–
– The master‘s KNX LED lights for 8-15 seconds
–
– The master restarts (takes several seconds)
–
– The master‘s M/E1/E2 LEDs light until the update finished. COM LED and RUN LED blink.
ERR RUN
Channels
Device
selection
1 4
5 8
M E2
KNX
Service
ERR RUN
Channels
Device
selection
1 4
5 8
M E2
KNX
Service
RUN
ERR
COM
RUN
ERR
COM
RUN
ERR
COM
ERR RUN
Device
selection
M E2
KNX
Service
RUN
ERR
COM
.
The behaviour the Error LEDs depends the KNX bus.
–
– both extensions the LEDs light for several seconds.
–
– When all LEDs off, the Extension restarts.
–
– The extension‘s update starts. power supplied via the KNX bus, all error LEDs
are off.
–
– When the application starts, all LEDs light briefly, then the device goes
into normal operation
