Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
004
Schematic (Bottom view)
COM
COM
Dimensions (thickness and width) terminal measured before pre-soldering.004
118 inch: ±0. 1mm .
ds 61284 te: 010113J 97
Automotive
. Condensation will cause
deterioration the relay insulation.012
Tolerance: ±0.)
(3) Atmospheric pressure: 106 kPa
The humidity range varies with the
temperature.039inch less than m
Min.
i Humidity, %RH
0 85
+32 +185
Temperature, °F
110
230
For Cautions for Use, see Relay Technical Information (page 166). Intervals between terminals measured surface level.
COIL
NC
NO
COIL
NOTES
Usage, transport and storage
conditions
1) Ambient temperature, humidity, and
atmospheric pressure during usage,
transport, and storage the relay:
(1) Temperature: +110°C to
+230°F (High heat-resistant type/Pin in
Paste type)
(2) Humidity: 85% (Avoid
freezing and condensation.1 ±.
(Temperature and humidity range for
usage, transport, and storage)
2) Condensation
Condensation forms when there a
sudden change temperature under
high temperature and high humidity
conditions.008
±0.3 ±.2 ±.118 inch:
Tolerance
±0.1 ±. Use within the range
indicated the graph below.(ACTE)
Twin type terminals type)
Pin Paste type
External dimensions board pattern (Bottom view)
Dim ension:
Less than 1mm .039inch:
Min.
