Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
The wave form should be
rectangular.
ds_61411_en_sfy: 200213D 607
Safety
.
3. Coil operating power
Pure current should applied to
the coil.
2. 00/12 230V (cosq>=1. Rating
UL/C-UL E120782
6A 250V AC, general use, 100Kops
6A 30V DC, general use, 100Kops, B300, R300 (pilot duty)
TÜV Cert. Soldering
When using automatic soldering, the
following conditions are
recommended
1) Preheating: 120°C 248°F, within 120
sec (PC board solder surface)
2) Soldering: 260°C+5°C 500°F+41°F,
within sec
For Cautions for Use, see Relay Technical Information (page 610).0) 70°C 158°F, 24V resistive
NOTES
1. Coil connection
When connecting coils, refer the
wiring diagram prevent mis-
operation malfunction. no: 968/EZ 535.
However, check with the actual
circuit since the characteristics may
be slightly different.SF-Y
SAFETY STANDARDS
Certification authority File No. includes ripple, the
ripple factor should less than 5%
