Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
Moreover, please consider safety measures that
high voltage part work cannot performed, not a
high voltage circuit OFF state with system structure,
when operating high voltage part work.) and should not be
installed near heat source. Contact welding may occur current switched by
contact turning current that exceeds the
specifications continuously applied when the power is
ON.
Moreover, order prevent from removing the assembly
screw easily, please attach the assembly screw showing its
backside. occurred, even the display window does not become
RED, please check the OFF state the contact with tester
etc.
7. The
performance cannot satisfied when reversely connected.
16.
10.
5 g
C n
t s
s . and sure wear protective equipment before
operating.
8. (Please refer ‘Description usage')
However when abnormalities such fuse disconnection
etc.
6 s
T w
t . Please consider safety measures such detection of
ON/OFF state high voltage circuit, earth fault detection,
and temperature detection system for high voltage
circuit. The screws for fixing switch-body and for additional
terminal should tightened with specified torque. Therefore, please
confirm enough with the system. Please abide by
the connection polarity described this catalog.
5. Take care avoid cross connections they may cause
malfunctions overheating. the switch dropped, should not used again.
9. Please not remove the assembly screw the switch.
It becomes cause the accident.
13. this not done, the electrical life will
decrease and cut-off failure may occur. from the switch for the
prevention electric shock. There possibility performance change due to
transfer effect through terminal from connected
components and radiation heat (e.
14.
6.
ds 61213 0004 151112D 565
Automotive
.
15. Please consider the layout which avoids conductive
liquid solvent such water etc. Attachment environment
< >
• t
• d
d .
2. When the short-circuit current large, there is
possibility that the switch will destroyed the time the
power supply intercepted with the fuse.(AEVD)
NOTES
1.
Otherwise the performance cannot guaranteed. the switch used for inductive load load) such
that L/R 1ms, add surge protection parallel with the
inductive load.
The switch indicates ‘RED' the display window contact
welding occur. the switch used exceeding the contact rating or
cycle lifetime, this may result the risk overheating.
12. Usage, transport and storage conditions
1 F
2 )
3 a
T e
r .
( d
s )
Humidity, %RH
'(Avoid freezing
/When used at
'temperatures
flower than
'0°C 32°F)
-40
-40
0
+32
80
+176
Temperature, °F
4 n
C n
t y
c h
i .
17.
4. Please note the polarity the terminal. fuse) around the
switch.g. The switch contacts are encapsulated type filled with gas. The switch should not installed near strong magnetic
fields (transformers, magnets, etc.
11.
< >
B )
T )
< >
B m
T m
3.
Therefore, care must exercised when the switch be
used stored high ambient temperature. the several switches are mounted closely heat-
generation object close the switch, take care check
the abnormal temperature-rise and the insulation distance
between the terminals outside the switch
