Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
O.: 28V DC
N. (Not freezing and condensing low temperature),
Air pressure: 106 kPa
Mass Approx. 0.: 28V DC
N.: Max.
*2.: 28V DC
N.O.: Max.C. 85% R.)
Breakdown voltage
(Initial)
Between open contacts 500 Vrms for min.5 16V DC
24 2.: Max.3 V
(By voltage drop
28 A)
N.: 14V DC
N. switching capacity (resistive load)*1 12V 24V DC
Electrical
characteristics
Insulation resistance (Initial) Min. 10ms (excluding contact bounce time) (Initial)
Release time (at nominal voltage)
(at 20°C 68°F)
Max.: 28V DC
Max.: 14V DC
N.7 (with resistor inside type) 1. bient tem perature and operating voltage
range (12V type)
Ope rating
/
volta range
/ /
V
/ /
7 y
/ /
7 -
/ /
\
Pick
(Co
\
-up v
dsta
oltage
t)
0 L
-40 -20
- Coil applied voltage, Coil applied voltage, V
0 8085 100 120
—- Ambient temperature, °C
530 61204 cm: 010113J
30
□ 25
20
= 15
10
5
. 44. 0. 0. 10ms (excluding contact bounce time) (Initial)
Mechanical
characteristics
Shock resistance
Functional Min.1 m/s2{4.2 125 96Q 1.71 oz
Notes:
*1. 0.O.3 V
(By voltage drop
28 A)
N.: Max.O. Please inquire you will using the relay high temperature atmosphere.C.4 8. Coil data
Nominal coil
voltage
Pick-up voltage
(at 20oC 680F)
Drop-out voltage
(at 20oC 68°F)
Nominal operating
current
[+10%] (at 20oC 68oF)
Coil resistance
[+10%] (at 200C 68oF)
Nominal operating
power
Usable voltage range
12 1. 105, Sealed type: Min. (Detection current: 10mA)
Between contacts and coil 500 Vrms for min.
REFERENCE DATA
1.O. carrying current
(at 85°C 185°F, continuous)
N. (Detection current: 10mA)
Operate time (at nominal voltage)
(at 20°C 68°F)
Max.5 V
(By voltage drop
14 A)
N.
Measured portion: Inside the coil
Contact carrying current: 0A, 15A
Ambient temperature: 85°C 185°F
2.5G}
Destructive
10 2,000 Hz, Min. .O. (at 500V DC, Measurement same location “Breakdown voltage” section.8 2. 104
Conditions Conditions for operation, transport and storage*2
Ambient temperature: -40°C +85°C -40°F +185°F*3,
Humidity: R.-(1) Coil tem perature rise (12V type, 85°C
185° F)
Sample: CM1F-12V, pcs.8 32V DC
2.: 28V DC
N.3 V
(By voltage drop
14 A)
N.4 320Q 1.O.: 14V DC
N.C.O.O. Refer “6.
Measured portion: Inside the coil
Contact carrying current: 20A, 35A
Ambient temperature: 85°C 185°F
1.: 14V DC
N. The upper operation ambient temperature limit the maximum temperature that can satisfy the coil temperature rise value.
*3. 200 m/s2{20G} (Half-wave pulse sine wave: 11ms; detection time: 10|as)
Destructive Min.CM
RATING
1.O.1 m/s2{4.: Max. 0.C. 44.C.2 4.: 14V DC
N.: 28V DC
Nominal operating power 1.O.C.5 1.-(2) Coil tem perature rise (24V type, 85°C
185°F)
Sample: CM1F-24V, pcs.O.: Max. This value can change due the switching frequency, environmental conditions, and desired reliability level, therefore recommended check this with the actual load.) Min. 1,000 m/s2{100G} (Half-wave pulse sine wave: 6ms)
Vibration resistance
Functional 500 Hz, Min. 106
Electrical (operating frequency: ON, OFF) Flux-resistant type: Min. Usage, Storage and Transport
Conditions” AMBIENT ENVIRONMENT (page 626).5 V
(By voltage drop
14 A)
N.H.5G},
Time vibration for each direction; direction: hours
Expected life
Mechanical (at 120 times/min.2 V
(By voltage drop
28 A)
Contact material alloy (Cadmium free)
Rating
Nominal switching capacity (resistive load) N. Specifications
Characteristics Item
Specifications
12 DC
Contact
Arrangement Form Form Form Form C
Contact resistance (Initial) Typ 2mQ (By voltage drop 1A)
Contact voltage drop
(after electrical life test)
N. 0.0 (with resistor inside type)
Min.: 14V DC
N.H
