Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
(Detection current: 10mA)
Operate time (at nominal voltage) Max.C.
Please inquire you will using the relay high temperature atmosphere (110°C 230°F).8V DC
(Initial)
75 160Q 900 16V DC
Max. switching capacity (resistive load)*1 14V DC
Electrical
characteristics
Insulation resistance (Initial) Min.5s OFF
Conditions Conditions for operation, transport and storage*2
High heat-resistant/Pin Paste type Ambient temperature: -40°C +110°C 40°F +230°F,
Humidity: R. 100 (at 500V DC, Measurement same location “Breakdown voltage” section.)
Electrical*4
<Resistive load>
Min. 85% R.(ACTE)
RATING
1. 10ms (at 20°C 68°F, excluding contact bounce time) (Initial)
Release time (at nominal voltage) Max. 7.7V DC
(Initial)
Min. 10ms (at 20°C 68°F, excluding contact bounce time) (Initial) (without protective element)
Mechanical
characteristics
Shock resistance
Functional Min.H. Refer “6.1 m/s2{4. 44. 44.C. 5.5V DC
(Initial)
Min. 0.
*3.O. carrying current (12V initial)*3 25A for minutes (at 20°C 68°F)
Nominal operating power
1,309 (Pick-up voltage 5.5 220Q 655 mW
2.12 oz, Twin type: approx. 107(at 120 times/min. (Detection current: 10mA)
Between contacts and coil 500 Vrms for min.Depends connection conditions. 105 (at nominal switching capacity, operating frequency: ON, OFF)
<Motor load>
Min. 0.5G},
Time vibration for each direction; direction: hours, direction: hours
Expected life
Mechanical Min.: Typ4mQ, N.
*4. Usage, Storage and Transport
Conditions” AMBIENT ENVIRONMENT (page 626). 1,000 m/s2{100G} (Half-wave pulse sine wave: 6ms)
Vibration resistance
Functional 100 Hz, Min.: 20A 14V DC, N.O.H. Coil data
Nominal coil
voltage
Pick-up voltage
(at 20oC 680F)
Drop-out voltage
(at 20°C 68°F)
Nominal operating
current
[+10%] (at 20oC 68°F)
Coil resistance
[+10%] (at 200C 68oF)
Nominal operating
power
(at 20oC 68oF)
Usable voltage range
Max. Therefore, please inquire when using with circuit that causes energized condition both sides simultaneously.: Typ5mQ (By voltage drop 1A)
Contact material alloy (Cadmium free)
Rating
Nominal switching capacity (resistive load) N.6V DC
(Initial)
109 110Q 1,309 mW
12V DC
Max.5V type)
655 (Pick-up voltage 7.The upper operation ambient temperature limit the maximum temperature that can satisfy the coil temperature rise value. 0. 105(25 14V motor lock condition), operating frequency: 0.
496 61284 te: 010113J
.5V type)
900 (Pick-up voltage 6.5s ON, 9.8V DC
(Initial)
54.5G} (Detection time: 10|as)
Destructive
10 500 Hz, Min.This value can change due the switching frequency, environmental conditions, and desired reliability level, therefore recommended check this with the actual load. 6. Please contact for details.
*2.: 10A 14V DC
Max.)
Breakdown voltage
(Initial)
Between open contacts 500 Vrms for min.23 oz
Notes:
*1. 3.5 . (Not freezing and condensing low temperature)
Mass Single type: approx.
* the relay used continuously for long periods time with coils both sides energized condition, breakdown might occur due abnormal heating depending on
the carrying condition. 6. 100 m/s2{10G} (Half-wave pulse sine wave: 11ms; detection time: 10|as)
Destructive Min.5V DC
(Initial)
Min.7V type)
Min. Also, this does not guarantee repeated switching.Do not use for lamp loads, electric discharge lamp loads, any other lamp loads and capacitor loads.5 . recommend that you confirm operation under actual conditions.1 m/s2{4. Specifications
Characteristics Item Specifications
Contact
Arrangement Form Form 2
Contact resistance (Initial) N
