Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
004
S tic tto )
_ il
n <
NO
c m
c m
The lamp control type has polarized contacts.3 ±.063 dia.378
6x1.2 ±.039inch: ±0.008
Min. .004
S tic tto )
c il
NO
NO
c m
c m
* The lamp control type has polarized contacts.039inch: ±0.378
6x1.425
Tolerance: ±0.276
.(ACTC)
DIMENSIONS )
1 Form type/Standard type s
Dim ension: Tolerance
Less than 1mm . 10. Intervals between terminals measured surface level.425
Tolerance: ±0.3 ±.
Connect COM the (plus)” side.063 dia.008
Min.
Connect COM the (plus)” side..276
T .8
7
.6 dia.2 ±.6 dia.
* Dimensions (thickness and width) terminal measured before pre-soldering.
Connect COM the (plus)” side. .1 ±.
6x.039inch less than .1 ±.004
Min.
ds 61282 tc: 060313J 491
c il
5
c il
c il
Automotive
.039inch less than .1 ±.
.004
Min. 1mm .
* Dimensions (thickness and width) terminal measured before pre-soldering.
Dimensions (thickness and width) terminal measured before pre-soldering.012
P tte tto )
”
^ ---
I . Intervals between terminals measured surface level.118 inch: ±0.1 ±.118 inch: ±0.
6x.012
P tte tto )
7
.118 inch: ±0.004
Min.3 ±.118 inch: ±0.012
P tte tto )
Tolerance: ±0. . 10.039inch: ±0.008
Min.004
S tic tto )
___c ________
n m
>c m
* The lamp control type has polarized contacts.. 1mm .1 ±.1 ±. 1mm .039inch less than .118 inch: ±0.
1 Form C/Standard type
E s
Dim ension: Tolerance
Less than 1mm .197 . Intervals between terminals measured surface level.8
\
- -
7
.
Double make contact Form type/Standard type
E s
Dim ension: Tolerance
Less than 1mm .118 inch: ±0.2 ±
