Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
.004
S tic tto )
COILr ^
' ojCOM
COIL
NOiç]
* The lamp control type has polarized contacts.1 ±.6 dia.1 ±.1 dia.4
— 4. the (plus)” side.
8.'157' . -*
2x. Intervals between terminals measured surface level.1 ±.2
. Intervals between terminals measured surface level.1 dia.004
Min.189
_(0.008
±0.039inch less than .2 ±.
Connect N.3 ±.008
Min.118 inch: ±0.039inch:
Min.
4x.
* Dimensions (thickness and width) terminal measured before pre-soldering. 1mm .012
P tte tto )
4./
- t
Tolerance: ±0.039inch less than .3 ±.512
8.
;
2x1. the (plus)” side.6 dia.063 dia.4
'.O.118 inch: ±0.043 . .8
2x1. 1mm .8
15T 189
Tolerance: ±0.8
4x1.
1 Form type
E s
4 8.004
Min.1 ±. Intervals between terminals measured surface level.118 inch: ±0.039inch: ±0.063 dia.
484 61280 tb: 010113J
COIL
.
3x.
4x1.
Connect N.
4x.O.004
S tic tto )
COIL
NC<5|^9
NOfoJ
-olCOM
COIL
* The lamp control type has polarized contacts.2 ±.2 ±. .039inch less than m
Min.4
4.331 "
Tolerance: ±0.012
P tte tto )
" i
xN 4.8)
¡1)
Dim ension:
Less than 1mm .1 dia.118 inch: ±0.004
S tic tto )
COIL
N ----------ojCOM
olCOM
Dimensions (thickness and width) terminal measured before pre-soldering.
■--0
8.8
,.039inch: ±0.004
118 inch: ±0.
Twin type terminals type)
E s
Dim ension: Tolerance
Less than 1mm .
2x1.(ACTB)
DIMENSIONS )
1 Form type
E s
Dim ension: Tolerance
Less than 1mm .008
Min.323
13
.118 inch:
Tolerance
±0.043 dia.1 ±.
* Dimensions (thickness and width) terminal measured before pre-soldering.6 dia.3 ±. 1mm .012
P tte tto )
3x1.
2x.1 ±.043 dia
