Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
The wave form should be
rectangular.)
The humidity range varies with the
temperature.1 seconds. Please keep continuous
power the coil within seconds.
2. not use the dummy
terminals wiring the board. However,
check with the actual circuit since the
characteristics may slightly different.
Schematic (Bottom view)
1 coil latching type coil latching type
Reset
coil
NOTES
1.
For Cautions for Use, see Relay Technical Information (page 610). includes ripple, the ripple
factor should less than 5%.
ds_61A04_en_dqm: 290213D 149
PolarizedPower
. Usage, transport and storage
conditions
1) Temperature:
-4 +700C +1580F
2) Humidity: 75% RH
(Avoid freezing and condensation.
Also, the power waveform should be
square and recommend least
0.4 (12 kgfcm).
Keep the installation torque within 1. Coil operating power
Pure current should applied the
coil.2
and 1.
However, not use the dummy terminals
as wiring the board. In
case wiring the dummy terminals, the
conductor destruction may occur due to
the high current. case wiring
of the dummy terminals, the conductor
destruction may occur due the high
current. Secure the PC
board dummy terminal designed for
reinforcement the terminal and use a
washer order prevent deformation. This could adversely affect
relay performance.
PC board pattern (Bottom view)
Note 1)
Note 1)
These are dummy terminals for the
strength reinforcement for the screw
terminal connection. Fix solder these to
the board case setting screw.DQM (ADQM)
DIMENSIONSm )
^C ADDat^ External dimensions
Download CAD Data from our Web site. Use within the range
indicated the graph below.
Note 2)
No 3rd terminal coil latching type. Installation securing screw
Do not apply excessive pressure the
terminals.
3) Atmospheric pressure: 106 kPa
Temperature and humidity range for
usage, transport, and storage
x(Avoid freezing
^ when used at
/ temperatures
/ lower than
^ 0°C 32°F)
5
-40 70
-40 +32 +158
Temperature, °F
3. Also, use
a spring washer prevent from
loosening
