Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
8 kgf} less
Please chuck the portion. Packing style
1) Tube packing
The relay packed tube with the
relay orientation mark the left side, as
shown the figure below.362±.
If the relay dropped accidentally, check
the appearance and characteristics
including M.8
mm inch
Tape coming out direction
8.9 {500gf} less
Chucking pressure the direction B:
9.
3.B.B.B.TX-D
NOTES
1.2±02
1 .
In addition, excessive chucking pressure
to the pinpoint the relay should be
avoided.75
(Z type)_______ ncri
TX-D relays
Tape coming out direction
(ii) type
Relay polarity bar ns5*. time before use.
C
For Cautions for Use, see Relay Technical Information (page 610). Check the actual circuit
carefully.
Chucking pressure the direction A:
4.008
(2) Dimensions plastic reel
mm inch
3) Ambient temperature when
transporting and during storage with the
product its original packaging:
-40 +70°C +158°F
2.
ds 61022 txd: 150113D 107
Signal
. type
A small OFF time may generated by
the contact bounce during contact
switching.« dia.425±.0 4. 2.B.0 050
m .1) stripe
.945±01 9.0
(Z type) ,
10.0 24. J
7^1
\
I UUU UUU UUU |J
Stopper (gray) Stopper (green)
2) Tape and reel packing (surface-mount
terminal type)
(1) Tape dimensions
(i) type
mm inch
Refay p°lanty bar 1.8 kgf} less
Chucking pressure the direction C:
9.
Orientation (indicates PIN No. M.0±02
■315 945 8±^
.. Automatic insertion
To maintain the internal function the
relay, the chucking pressure should not
exceed the values below.
Avoid chucking the center the relay