Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
1 ^
.
3.
330=2dia.
12.0 *0:
945 *012
(ii) SL, type
Relay polarity bar
(Z type) 1.300
_ -
Schematic (Top view)
Single side stable 1-coil latching
1 5
7Direction indication
(Deenergized condition)
1 5
Direction indication
(Reset condition)
2-coil latching
10 6
r -
(Reset condition)
NOTES
1. 157
.016
mm inch
40 .453*.248=008
Relay polarity bar 40
(Z type) 1.992*079dia.5T dia.8 kgf} less
Chucking pressure the direction B:
9.9
.193 i
^ .
C B
For Cautions for Use, see Relay Technical Information (page 610).O75
Note) *SS type
24.
.TQ
2.150* dia.0*0
(10.
88 ds_61020_en_tq: 060213J
.
- f
SS type
4. Automatic insertion
To maintain the internal function the
relay, the chucking pressure should not
exceed the values below.~ 059*0
.9
.5=0.1) stripe
[ Ki±]
» mini innrani mini minim
Stopper (gray) Stopper (green)
2) Tape and reel packing (surface-mount
terminal type)
(1) Tape dimensions
(i) type
mm inch
0.300 1
_ 11.193
± -
^ T
. Surface-mount terminal
^C ADDat^
Type External dimensions (General tolerance: ±0.
.5_.453=.398)*
T com ing out direction
(2) Dimensions plastic reel
mm inch
80*’ dia.
.4 ,l.8 kgf} less
Chucking pressure the direction C:
9.
Chucking pressure the direction A:
9.020
SL type
^ . Packing style
1) The relay packed tube with the
relay orientation mark the left side, as
shown the figure below.
Avoid chucking the center the relay.016
6.3 ±.
Orientation (indicates PIN No.012) Suggested mounting pad (Top view) (Tolerance: ±0.484
T ape com ing out direction
24.1 ±.
In addition, excessive chucking pressure
to the pinpoint the relay should be
avoided.3*° 2
.
2.300 1
_ .059*r4dia.5+0
0.8 kgf} less
Please chuck the portion.4_
.004)
SAtype
4
