Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
1 ±. 350°C 662°F (solder temperature),
within seconds (soldering time)
The effect the relay depends the
actual board used.30/ .
81
85
Dim ension: General tolerance
Max.085
3x1.B 3x2.G/1
Tolerance: ±0.331
L 1/.15
..118 inch: ±0.CB
5./05
1B.8
3x.G/^ ;:_C3(
3¥2.G85
/.039 .1 ±.118 inch: ±0.15
3x.004
* Intervals between terminals measured surface level.102 3x.012
NOTES
1.8^— hrh rh
3x.039 inch: ±0.
(Temperature and humidity range for
usage, transport, and storage)
Humidity, %RH
85 110125
-185 +230 +25/
Temperature, °F
For Cautions for Use, see Relay Technical Information (page 166).
126 61202 cb: 010113J
.004
1 .
2.8
. Use within the range
indicated the graph below.)
(3) Atmospheric pressure: 106 kPa
The humidity range varies with the
temperature. High contact capacity type Form (PC board type)
External dimensions Schematic (Bottom view)
Including resistor type also available
PC board pattern (Bottom view)
2
1.8
30/
^ .3 ±.BB1
3x1. Please verify the
PC board used.008
Min.9
.2 ±. 1mm . .4 2. Usage, transport and storage
conditions
1) Ambient temperature, humidity, and
atmospheric pressure during usage,
transport, and storage the relay:
(1) Temperature: +85°C to
+185°F (Standard type)
-40 +125°C +257°F (High heat-
resistant type)
(2) Humidity: 85% (Avoid
freezing and condensation. Soldering
Max
