Poznámky redaktora
The test voltage must higher than
100 VDC start the RUNNING sequence. From the entered coefficient and nominal resistance
calibrator calculates resistance level which will connected during RUNNING mode the output
terminals
Following additional parameters are displayed DAR mode.
- DAR/PR/PI coefficient. Connect UUT the output terminals. Calibrator connects resistance value
R0 the output terminals and waiting for test voltage from UUT.
- Accuracy actually connected resistance %. One defined parameters DAR/PR/PI can selected.
B.
C. Write requested resistance value using the
numerical keypad and range buttons kQ, MQ, GQ, and push ENTER button rotary button confirm.
User Manual v16 21
.11 ProgrammingtheDPPmode
Following parameters can entered:
- PARAMETER field.
During running mode currently applied test voltage and total elapsed time are displayed.0 Mil' cDfl: 1. Use test leads delivered with UUT whenever possible.
- out value.
In DPP mode the display shows information follows (OFF submode):
R0S 100. Both type requested parameter,
nominal resistance and parameter index can set. The time which has been elapsed after the starting RUNNING sequence. Requested value the coefficient which asked simulate can entered. Reading currently applied test voltage displayed.
- Total time.r. actual resistance value which currently connected the RUNNING mode the
output terminals.
Range the value from 0. When presence the test
voltage recognized, calibrator goes over RUNNING mode. kU
Total time: 0.
Write the coefficient and confirm pushing the ENTER button. When requested parameters are set up, push the OUTPUT button.0 s
Mode :
DPP
Accuracy
Fig. Use rotary button select and enter parameter R0, PARAMETER and coefficient.
- max parameter maximum applicable test voltage.
D. M191 Insulation Tester Calibrator
OFF OFF mode the output terminals are disconnected. When the sequence finished, calibrator stays in
RUNNING mode until the output terminals are disconnected using OUTPUT ON/OFF button.
STANDBY When OUTPUT button pushed, calibrator goes over STANDBY mode.
RUNNING Calibrator simulation sequence has been launched.MEATEST, s. Select requested type of
parameter and confirm with ENTER button rotary button. Calibrator switches the setup resistances to
the output terminals preset time intervals.: ---------
Umax" kU
OFF f
Local
Gnd
Te^t 1ta*ie:-U.5 99.
- Test voltage.
The parameter range from 100 GQ.. Use only test leads with guaranteed isolation according test voltage
range UUT.
- parameter.000
pnn. Select DPP mode pushing repeatedly FUNCTION FUNCTION DOWN button until DPP label
appears the display. This the resistance which connected the output terminals STANDBY mode.o.t. this mode
is waiting for test voltage from UUT start simulation sequence.9.
Operating procedure
A
