Multiple settings can stored
in Memo and Memo and re-called set several
devices. press and 5’
for time value 7’
Day level
1000 Lux
LED set the value 1000 Lux
Learn LED learn the current Lux level
Corridor
200 Lux
LED set the value 200 Lux
Office
400 Lux
LED set the value 400 Lux
Lux LED increase the Lux level (+100)
Lux LED decrease the Lux level (-100)
Active cell Green LED The light continuously measured
Passive cell RED LED The sensor will not switch the light off even the
ambient luminosity sufficient
Memo and set Key Meaning Indication Function
Press LED until setting changed load/unload Memo 1
Long press LED for 5s, then will blink until
released. After release, the LED goes off in
case setting change
To save the current setting Memo 1
Press LED until setting changed load/unload Memo 2
Long press LED for 5s, then will blink until
released.
In the case opposite states the green LED denotes
ON and red LED denotes OFF (except Presence /
Absence).
When function selected all LED’s are OFF.
The SET key used send the messages the
occupancy sensors. When the potentiometer is
on auto test allows single and multiple settings.Data subject errors and technical modifications.
Single setting
Example: reset
Multiple settings
Define the parameters changed and press SET
to send.
+
+
+
+
.
Lighting,
Connection
&
Control
Klik
IR Commissioning Remote Control (EEK001)
Settings available
Key Meaning Indication Function
Presence Green LED Presence (automation mode)
Absence Red LED Absence (semi automatic mode)
Power Green LED The light automatically switched for seconds
after power up
Red LED During warm phase, the light output off
Reset LED return factory settings (Lux 400, time min,
presence on, power off and cell active)
Test LED validate the detection area
Time LED set the time
It possible add times together e.g.
Example: for minutes and corridor use, press 20’, 5’
and corridor.
Technical specification
Power supply:1x CR2032
Shelf life battery: years
Protection index: 30
LED
The acknowledgment
LED blinks during
the sending the IR
message. After release, the LED goes off in
case setting change
To save the current setting Memo 2
Short press (<5s) LED flashes send message the current setting
Long press (>5s but <10s)
only available setting
active
LED blinks until release press toggle automatic mode DALI/DSI
Use
The remote control allows the user set modify
presence detector settings
