|
Kategorie: Leták / DatasheetMIX datasheetů a jiných letáků |
Tento dokument chci!
BZD 30 - POKOJOVÁ ANTÉNA PRO DVB-T
Použití: Aktivní anténa je určena k příjmu digitálních pozemních televizních a rozhlasových signálů ve III.(VHF) a IV. a V.(UHF) televizním pásmu. Používat pouze s vhodným přijím ačem pro DVB-T s napájením 5 V. N epřipojovat na satelitní přijím ač!! Všeobecně: V oblastech s malým nebo naopak velmi silným signálem není nerušený příjem vždy zaručen. V případě slabého signálu je vhodné použít venkovní směrovou anténu. V bezprostřední blízkosti vysílače může být příjem ovlivněn příliš vysokou úrovní signálu. Příjem v místnostech může být ovlivněn dalšími faktory. Kritická místa jsou například místnosti v železobetonových budovách ...
The instrum ent then reverts the search display the previous selection. you have defined own carrier, too can viewed spectrum mode.
Tip:
13
. High Band selected, the KHz tone symbol appears alongside the polarity. Pressing the DOWN button allows the span selected value between MHz (especially for zooming carrier) 1200 MHz. The screen switches over and displays the spectrum. The Low Band covers the range from 10,700 MHz 11,600 MHz and the High Band the range from 11,550 MHz 12,750 MHz, that the Low Band and the High Band for universal LNB overlap somewhat.OPERATING MENU
SPECTRUM MODE
Spectrum mode can entered via the sub-menu (press the button until the signal level the Carrier-to-noise ratio shown the display). The spectrum information bar the top this screen will alternate between the current frequency and span use. There are areas between the carriers which there are low-level signals, and the larger the distance between peaks and valleys the better the carrier-to-noise ratio. The display centred the frequency the selected transponder (in the example shown, the Low Band set 10728 MHz). good carrier-to-noise ratio important for fault-free reception! The top line the display can switched between “Centre” with the selected frequency (displayed the dotted vertical line the middle the display) and “Span” MHz. Use the LEFT and RIGHT buttons centre the selected frequency the display.
Note:
You can exit spectrum mode any time pressing the button once. the “Span” view, the polarisation the carrier shown (H)orizontal (V)ertical. Switch the “Spectrum” line and press the RIGHT button. The level shown bar each sampled frequency (see diagram). These limits are marked with arrow the right (lower limit) and the left (upper limit). The “Span” frequency display range (the frequency range displayed the screen) set standard 240 MHz, allowing adjoining carriers with MHz spacing shown. Please note that you will not able beyont the limits for each band