Poznámky redaktora
For most applications, one
half the connector, the “fixed” connector, mounted permanently the
machine, system switch cabinet. These definitions and terms clearly state the
difference between plug devices and connectors.
Connectors are easy use, usually without tools, and offer safe termination
and fast disconnection lines. However, other product has spread throughout industry rapidly
. the product descriptions, not
elaborate property rights and patents. contrast, plug device a
component that may connected disconnected, used intended, a
live circuit under load. This may include main power lines well control lines. The other half, the “free” connector, is
placed one end cable.2 History
The history industrial connectors relatively short.
1. The author disclaims responsibility for any errors that might
occur the information provided, even though due care was taken avoid
such errors.
Therefore, the reader who would like adopt some the ideas for their
own use should acquaint themselves with the current rules and perhaps even
patent rights.
1.Introduction 17
1 Introduction
This manual intended simplify the handling and use industrial
connectors. addition describing and presenting the various systems, it
also deals with current regulations and standards. Industrial connectors,
as know and use them, have only been around for approximately 50
years. Connectors consist two main parts,
namely the male section and the female section. However, does not and
cannot substitute these regulations.1 Definition
Connectors are components used establish removable connections for
electrical lines. The regulations mentioned refer those
currently valid (August 2000). The following information
relates only connectors.
A connector device that should not connected disconnected a
live circuit (in accordance with VDE 0627). The author would pleased receive the reader's feedback on
any errors. With cable cable connections, both parts are
free
