Poznámky redaktora
The system, common Germany
for decades, was replaced the international metric system.6: Cage clamp terminal
2. screwdrivers, open-end wrenches,
etc. cable gland matching the cable diameter is
required for tight seal and for cable strain relief.
- Machine-processed contacts should used when pre-assembling cables
with connectors. for motors), switching cabinets,
encapsulated switchgear well control devices and housings general. crimping tool, automatic crimping
tools, etc.g.2. Mainly
affected this are electrical installation conduits, cable glands and cable
inlets, cable distribution boxes, installation boxes, distribution cabinets,
domestic service boxes, terminal boxes (e.
- Termination with special tools, e. 2.26
One conductor per terminal
Screwdriver insertion point
a l
Fig.2.g.3 Cable Size (cable glands)
When connectors with housings are used, the size the cable inlet must be
taken into consideration.
The new millennium was accompanied important change for the
electrical industry and its tradesmen.
When selecting termination method, important take into account
how and where the connector used.
2.2 Termination Method
The connectors are designed for certain termination method. Here, we
differentiate between two general termination methods:
- Termination with standard tools, e.
.g.
- Standard tools are preferred for on-site construction (at the system or
machine)
