The surface
of the strands can bare, tinned silver-plated. However, to
ensure reliable connection the following points need taken into
consideration:
- the suitability the wire combination with regard material and finish
- the inside diameter the crimp sleeve should match the combined
cross-sectional sum all conductors.1.25 3.
Press-in termination (post)
A termination having specially shaped section suitable accomodate a
press-in connection
. round solid wires are to
be crimped, each case should assessed separately. Terms and definitions related printed boards
are given IEC 194.
General requirements and testing methods for press-in connections are
specified DIN 60352-5. is
however important ensure that the construction the connector the
press-in area, should able withstand insertion and removal forces.1.9 Crimping multiple wires one crimp sleeve
It permissible crimp multiple wires into one crimp sleeve.
- must satisfy the requirements for tensile strength and contact
resistance.8 Stranded wire conductors Solid wire conductors
As rule, stranded wire conductors are used for crimp terminals.1.
4.
Press-in connection
A solderless electrical and mechanical connection made inserting a
press-in termination into plated-through hole printed board.4.94
4.1.3.6 should used.4 Press-ln Termination
The press-in technique used rarely for industrial connectors.
4.
4.3.1 Terminology
(Extractfrom DIN 60325-5) For the purposes this section the terms
and definitions oflE (581) and IEC 512-1 and the following additional
terms and definitions apply. The standard specifies
that only conductor diameters 0. can provide
an economic solution for interfaces, which transmit control signals
