Input Level Controls
This for adjusting input sensitivities. RCA inputs
RCA cables marked FRONT REAR from head unit other line level device should connected here.
4. the HPF position adjust the frequencies from 40Hz-178Hz, the low frequencies are filtered out and allowing the amplifierto
play mid and high frequency.
3.
GB. Status LED indicators
GREEN indicates the normal operating condition: the amplifier ON. adjust the sensitivity, turn the controls fully counterclockwise minimum. Use both inputs for front and rear stereo. the amplifier used power midrange and tweeters coaxial type speakers, set the crossover HPF. the amplifier used power
subwoofers, set the crossover switch LPF. CORSSOVER
This for adjusting LPF HPF frequencies; the LPF position, adjust the frequencies from 66Hz-275Hz, all the high frequencies are filtered out and the amplifier
produces only low bass frequencies.
Switch the crossover FLAT when amplifier used Tri mode configuration when full range speaker are used.
2.
On the contrary, the HPF position, the low frequencies are filtered out and allowing the amplifier play mid and high frequency. RED indicates the Amplifier protection
5. Crossover Selector (HPF/FLAT/LPF)
This switch allows these two amplifier channels play full range, low pass, high pass. the LPF (Low Pass Filter) position, all the high frequencies are filtered out
and the amplifier produces only low bass frequencies. Adjust the radio/head unit volume knob maximum
volume, and then turn the level controls the amplifier clockwise until audible distortion occurs.GB
SAC 2090 CONTROL FUNCTIONS
1
