.+45°C
Informations
Accessories
General Properties
Housing Mounting Connection
flammability according Standard 94: V-2 halogen-free For stripped-free and stationary connection directly the ecobus® combi-cable matching ecobus® connection cable see page E-30
Article No. The device does not require any additional power supply. Depending the chosen application, the following functions can set selected using the parameterization software: Switch functions: Blind functions: selection preferred position case malfunction stop time for change direction invertibility outputs monitoring time for wind sensor priority object safety case wind alarm linking, confirmation run time blinds time switch operation impulse time for slat adjustment on/off switch delay Power supply via ecobus® EIB
Actuators
Connectors
Technical Properties
Outputs Drive supply EIB switch voltage Switch capacity
2 binary outputs for 230 consumers blind output for 230 230/400 V~, 50.ecobus® Actuator B-1J/2S W
Decentralised office actuator binary output; set blinds
Building Systems Technology
Similar figure
Product information
Cables
Application
The ecobus® EIB Office Actuator B-1J/2S with potential-free contacts serves switch two independent electric consumers and controls one blind drive UP, DOWN and stepwise slat adjustment OPEN, CLOSE over ecobus® EIB.
EIB/KNX European Installation Bus
. 230 resistance load max. cross section mm
2
Weight g/Unit 342
Dimensions app. (blinds), resistance load max....60 Hz, max. 254 112 32
Fire load kWh/unit 2,6
Packaging Unit Unit 1
5 2,5 1,5
E-36
Technical changes reserved. 1301 221
for nom. (lighting) Housing light gray, RAL 7035 Mounting type wall surface, attachment with screws Protection type Ambient operating temperature -5°C
