The use of innovations and new technologies at Hageris always customer-driven. Every year, Hager evaluatesthousands of its customer contacts, resulting in detailedknowledge of its customers’needs in order to workefficiently and successfully.
96
95 %
11.
Up Tronic transformers with 1-10 interface can regulated the control
side with electronic rotary potentiometer 1-10 and 250 with the
push-button control unit 1-10 built-in. 2.
Cutting template
Info pilot lamp insert
Info pilot lamp
insert
Switch-off
Control circuit
The neon lamp lights only when
the info light signal switched on.By the use monitoring switch, the state the info pilot lamp can also
be also indicated different location. The labelled sheet selected from the supplied range can optionally be
placed above below the factory-fitted milky cover, depending whether the
notice (or pictograph) visible all times visible only when the light signal
is on. 2977
75 maximum load
max. This allows electronic ballasts be
combined with 1-10 interfaces. maximum load
Tronic transformer with 1-10 interface
Housing temperature tc
Secondary lead
Short-circuit protection
Overload/temp.
Remove detachable contact
lug from the neon lamp unit.8 mA
max..: insert
Order no. 0.g.
Continuous illumination
Change-
over switch
55
55,7
25
L
2949
N
L
N
L
2949
N
red
3036
L
N
red
3036
L
2949
N
L
N
Surgery
Info pilot lamp
insert
Change-
over switch
Info pilot lamp
insert da
2897
dada
2897
da
N
-
L
2
da
daDALI
DALI
230 V~
N
L
L
N
To other rotary potentiometers
DALI (max.5 mm²
electronic, automatic restart
Automatic power reduction
cut-out case fault
Protected
via 1-10 interface
II
Screw-type terminals for max. When dimensioning system, the control and
load currents must considered separately!
Technical data
Nominal voltage
Primary rated current full load
Power range
Power factor
Efficiency 9
Rated output voltage
Softstart
Control current
Operating temperature ta
230 V~, Hz
0. 2897
16 (9.5 mm2
or 1.
This permits convenient dimming even high power outputs from one central point
or from several distributed points.
Info pilot lamp
with green cover
Technical data
Rated voltage
Nominal current
LED power
Switching frequency
Service life
Light colour
Operating temperature
Index protection
Terminals
Order no.5. protection
Fire prevention
Open circuit
Dimmable
Protection class
Terminals
Order no. 64)
Technical data
DALI voltage (IEC 60929)
Current input
DALI control line length max. mA
approx.5 V=)
less than mA
at 0,5 mm2
100 m
at 0,75 mm2
100 150 m
at 1,5 mm2
over 150 m
F 500 250
5 °C
Screw-type terminals for max.
Fine-wire fuse
Operating temperature
Terminals
Rotary potentiometer DALI order no.5 mm2
or mm2
Rotary potentiometer DALI (Digital Addressable Lighting Interface)
To other Tronic transformers or
electronic ballasts with DALI interface
Control and load cables must not laid
in the same cable conduit. 2.
Changeover switching
Rotary potentio-
meter DALI
Rotary potentio-
meter DALI
Mains power
unit
(DIN IEC 60929)
Electronic ballast Tronic
transformer with DALI interface
Please enter
Tronic transformer with 1-10 interface
In complex modern lighting systems, lamps are increasingly being operated way
of electronic ballasts (German:"EVGs") fitted with 1-10 interface.: cover
Insert and info pilot lamp cover with label sheets
230 50/60 Hz
approx.5 mm2
or 1.8 V
Bulb-preserving switch-on
approx. This 1-10 interface now offered with the
Tronic transformer. 2.22.
Application: e.
The brightness illumination when there
are DALI telegrams (PowerON-Level)
and power failure the DALI system
power (SystemFailure-Level) are saved
integrally within the electronic ballast and
cannot changed the DALI
potentiometer. waiting rooms, outside conference rooms,
doctors' surgeries, etc.5 mm2
2949
1345 . long, min 1. 800 mW
any
25,000 hours
white
10 °C
IP20
Screw-type terminals for max.5 mm2
1-10 control
module
12 connection
1 -10 V
interface
230 V
Connection
DALI/Electronic ballast/Tronic transformer
.T29
Info pilot lamp
The info pilot lamp marked uniform illumination and clear visibility (even from
the side).They can printed colour monochrome black using an
inkjet laser printer, transparent projector sheets..45 A
20-105 W
0.
Self-production text and graphical signs
Using computer and appropriate software, possible produce your own text
and/or graphical signs.
