Poznámky redaktora
For further information the PR120/D-M communication MODULE, see paragraph 15.4.
Model 2234 Apparatus Scale
L 2778
Doc 2
Page No. After entering password you can choose whether the neutral connection Absent Present.
107/158
.
14. The addressing
can selected standard Modbus ABB.5..4.4. The physical protocol provides for the options: (8,E,1), (8,0,1), (8,N,2), (8,N,1).s
When you access the Settings menu, there set menus available relating the modules.
On the page only with Vaux, you can also see the state the circuit-breaker "STATUS", and thus make sure that the input correctly wired.
14.
Using the "Trip Test" function lets you view the disabling/enabling the Trip. For further information, see the description the module paragraph 15.2 this
manual. The function only
available with busbar current nil (use Vaux, PR030/B PR010/T).4.5.4.4..3.5.
14.5.
14. 1150V) and secondary voltage (100, 110,.4.4.
14.4. The serial address can displayed after entering password. enabled, the circuit-breaker opened. Moreover, you
can select the values the primary voltage (100, 115, 120, ..4 PR120/D WL-COM odule
This module for wireless communication based the Bluetooth standard between the PR123/P protection release and hand-held (PDA)
or laptop with Bluetooth port.1 PR120/V MEASURING odule
MEASURING module
COM module
SIGNALLING module
Communication parameters
Modules 1/4 MEASURING module 1/4
Voltage Transf
Rated voltage
Positive Power flow
Absent
In the measuring module you must enter password and can then opt for the absence presence the voltage transformer.
Menu 4/5
Measures ▲
Settings
Devicetest
Enter J
Password Test 1/6
Enter status 1
0*** Auto Test
------------------------ Trip Test (disabled)
Enter password CBopen
The menu shows the state the CB, the dialog module (COM module) the state the springs and the position the CB, and this submenu
you can make the open close. The power flow can Bottom
-> Top Top Bottom.5. For three-pole
CBs only.5 Test Menu
Access the Test menu password protected. The Baud
Rate can set the values 9600 and 19200 bit/s.4.5.,230V).5 Settings for the Local Bus unit
If the PR021/K unit connected, you need enable the local bus selecting present.4.
14.2 PR120/D-M COM odule
Modules___________________ 2/4
MEASURING module
COM module
SIGNALLING module ▼
Communication parameters
COM module 1/5
Local Remote
Serial Address
Baudrate ▼
Local
The local remote modes can selected after entering password.3 PR120/K SIGNALLING odule
For thorough examination the signalling module, refer the corresponding section the module, paragraph 15
