Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
tin g
• not remove the cover.
To prevent damage and deformity,
please use torque within the following
range when tightening the push screw
block the term inal socket.2
3 0.25
15 2
20 2
30 3.
Since the affect adjacent mounting
differs according the type relay, refer
to the data for the particular type. Mount relays with sufficient
spacing between them prevent heat
buildup.784 0.
4.49 0.666 m
(15 fcm )
M4
1.)
The socket should pushed through
the opening the mounting panel until
the projections the side the
mounting bracket extend out over the
back surface.37 m
(12 fcm )
M3. (It will not come off
under normal handling.
Perm issible current
(A)
Cross-section
(m 2)
2 0. tio s
• hen making the connections,
depending upon the size load, the
wire cross-section should least as
large the values shown the table
below.)
[9] METHOD MOUNTING AND LEAD WIRES CONNECTION
1. has a
special function.69 to
7 fcm )
ds_x61_en_relay_technical_information_091112D 19
.
This also applies when large number of
boards mounted with relays are installed
as card rack.
W d
After drilling the mounting holes, the
term inal socket should mounted
making certain the mounting screws are
not loose. sure the ambient
tem perature the relay does not exceed
the value listed the catalog.5
1.3
5 0. tin d
The direction mounting not
specifically designated, but the extent
possible, the direction contact
movement should such that vibration
and shock will not applied.
• flu tin f
p s
W hen polarized relays are mounted close
together, their characteristics change.5 0.378 inch width.039 to
.
To remove the socket, the projections
on the side the mounting bracket
should pushed inward and the
same tim the body the socket
should pushed lightly from the back
side.5
0.5 1.75
12.98 (8
to fcm )
M3
0. The socket can then removed
from the panel.079 inch should used.General Application Guidelines
3 tin g
W hen many relays are mounted close
together, abnorm ally high tem peratures
may result from the combined heat
generated.
W hen all four the projections are
visible from the back side the
mounting panel, the mounting is
completed and the socket fastened. DIN standard sockets are
available for one-touch mounting DIN
rail 35mm 1.
2.
Screw Torque
M4.
(A panel thickness .176 1.
W re
u d
• The reversible term inal sockets (HC,
HL socket) are for one-touch mounting.5
W hen the term inal socket uses screw
fastening connections, either pressure
term inals other means should be
used make secure fastening the
wire.5
7.47 1
