Panasonic is part of a large worldwide groupselling relays and associated switching products under different brand names in different territories.The conditions of use in some territories may differ from those customary in Europe. In particular there are often major differences in regard to national and international specifications, such as UL, CSA, VDE, SEV, EVE, SEMKO, etc. Thus, when considering contact loads as stated in this catalogue (e.g. 10 A, 30 VDC for the SP relay) its hould be understood that these values are not necessarily an absolute maximum but tested ratings. Mostly the stated value has been tested for a certain life expectancy as stated by the manufacturer or the respective test house. Thus, under different conditions, the stated “maximum” may, in practice, be safely exceeded.
guide, the insertion strength the plug-in terminal
into the relay tab terminal should 70N (10A type), 40
to 80N (20A type). Condition tightening screw
T .
5.
T )
p e
t l
d .
E .
1 l
2 l
11.
• d
t h
c .
( )
8.
1 a
2 a
8 a
1 e
2 e
3 e
M a
M a
M a
10.
Also, please use the following materials for connected
harnesses and bus bars.
3. Permeation life internal gas
T e
c t
a b
t e
F r
b y
M s
b .
6.
2. careful that foreign matter and oils and fats kind don't
stick the main terminal parts because likely cause
terminal parts give off unusual heat.
M . The coils (300 type) and contacts (all type) the relay
are polarized, follow the connection schematic when
connecting the coils and contacts. For the 300 type, drive the coil with quick startup.
< >
• m
• 4
N m
< >
• m
• m
• m
4.
9.
B e
g .
12. When installing the relay, always use washers prevent
the screws from loosening.
T c
t ., Because might adversely
affect the opening and closing performance.(AEV)
NOTES
1.
5 s
T w
t .
3 a
T d
s e
Humidity,%RH
85-
ITolerancerange
/(Avoidfreezing_(Avoid //////Whenusedat condensation
/temperatures whenusedat ////
flowerthan temperatures ////
/0°C32°F) higherthan N//
5: 0°C32°F) Y/,
V/V/V/V/V/V/V/VT/Vm
-40
-40
0
+32
80
+176
Temperature,°C°F
4 n
C n
t y
c y
i .
Do not repeatedly turn OFF within that 0. After the signal enters the 300A type, automatic coil
current switching occurs after approximately 0.1 seconds
interval, doing may damage the relay.
7.
• e
u . Avoid excessive load applied the terminal case of
installing such bus bar etc. Use the specified connector for the connector terminal
connection (80A, 120A and 300A)
Y t
ds 61213 ev: 190313D 553
Automotive
. Electrical life
T l
b e
c g
c m
l )
I a
p o
c n
s .1 seconds. Usage, transport and storage conditions
1 F
2 )
T e
r .
I e
b . Please select plug-in terminal (flat
connection terminal) which comply with JIS C2809-1999