Usměrňovačové systémy DC-Měniče Střídače UPS systémy ...
Poznámky redaktora
. The individual tests (depending the pre-set
ting the test procedure) are displayed subsequently and partly have activated confirmed
by pressing the rt> button (also see description the individual measuring types, chapter 8). case negative connection test (e... possible filter and search for different parameters like e.
08/ 2012 58
. The test intended determine whether dangerous contact voltage
is applied, whether test sample connected and make sure that there short-circuit.
open switch), information message displayed..)...), depending the customer database!
- Select the test sample the "ID no.
Untick the box "Display All" and enter the corresponding date the field
"NextTest" means ofthe calendarfunction.1 earch Test ples
Automatic Test
Database
--------------------,
|Alfbns New Test Sample |
Customer
|Hartmann _▼]
ly Display All
ID no.... arrying the Integrated tic Test
Test samples already existing database can tested rapidly means the automatic test....
Now, the menu the selected test sample opens.. After the test has
been successful and finished, the "Test sample OK" menu displayed........g..
12.g.... the test cable
with the alligator clip probe tip can connected another measuring point without resulting in
incorrect measurements indications.". Next test
Ili..BENNING BENNING 750 A
12.. The values are highlighted grey colour and
cannot modified this menu! After pressing the rt> button, first the "Visual Inspection"
menu displayed.. ofTest Samples" and
"ID no. |29/06/2010 LlJ
No... pressing the button, possible interrupt measurement that e. In
case faulty individual results that are dangerous, the measurement will interrupted immediate
ly..
Attention! The mains voltage applied the test sample will persist during the "Test interrupted" mes
sage! Incorrect measured values can deleted pressing the ese button. The measuring
data will stored the selected database (name) and can read out via PC.. means of
the "Search Field".g. possible display the
results pressing alu and save them pressing >).
The sequence described here applies already existing database (name), customer (name)
with registered test samples (ID no. After pressing atic Test> the start menu, select the
following the menu displayed:
- Selection the database (name), only specific customers!
- Selection the customer (name), only specific test samples!
- Selection the test sample (ID no..." line and mark means the input stylus. Test ||2 Search Field
of ||2 1
Back Database Input About |
By means the fields "Display All" and "Next Test", you can select the test samples a
specific "Database" and the corresponding "Customer" which shall tested specific date.. the no.. Confirm pressing button... After positive test and pressing button, a
connection test started. After
a positive connection test, the measurement started. The result shown the fields "No...
