Poznámky redaktora
12. password will then required enable
you switch the editing mode.
Starting from any page displayed, after about 120 sec inactivity, the default page will automatically displayed (see par.
The functions allowed depending state are:
“READ” :
■/ Consultation the measurements and the historical data
■/ Consultation the unit configuration parameters
■/ Consultation the protection parameters
“EDIT”:
■/ Everything allowed READ mode
■/ Configuration the unit
■/ Programming the parameters relative the protections
■/ TEST Functions the unit
To access the "EDIT" mode, necessary press the key page with fields which can edited.4.2 Read and Edit modes
The menus map (see par.1) shows all the pages which can obtained and how move between them from the keyboard, the "READ"
mode (just read the data) the "EDIT" mode (to set the parameters).5.
38/1 08
. 12. Two examples are provided below: one concerns the case which confirmation needed for the changes you have made, while
in the other confirmation window appears.
After any programming, you need Confirm/Cancel/Change any changes you have made.1).3 Changing parameters
Moving within the Main Menu you can reach all the pages relating the configurations and parameter settings with the opportunity change
the values specified for the parameters. No. This procedure not applicable all the programming
activities.5.
The use the keys summarized the following table:
Key Function
HfS Move between pages
Move within menu
Chanae parameter values
m
End setting phase and confirm result
Choose menu item
Access surfing menus from the default page
Return previous level when surfing within the menus, until you return the default pages
Exit the parameter changing phase, aborting the change
This key used re-enable the display after has gone off within hours the opening the circuit-breaker
in self-supply mode.
12.4. 1SDH000635R0002
Page No. 12.
Procedure not requiring the confirmation any programming
For instance, set the System Date, the correct sequence follows:
From the default page press ESC
to access the Main Menu
From the Main Menu, select SETTINGS
press the key (enter)
Select SYSTEM
press the key (enter)
Select the menu item DATE change
press the key (enter)
Menu 3/5
Protections ▲
Measurements
Protections settings
Settings 7/8
Datalogger
Measuring interval
▲
System settings
System____________________ 1/4
Date
Time
Language ▼
January 12, 2003
Model 3447 pparatus cale
Doc
